Guest User!

You are not Sophos Staff.

This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Can't find the NIC

Trying to install Astaro - previously had Linux on my system with on-board ethernet and two Dlink DFE-538TX cards. Linux saw all three cards fine with no drivers.

Trying to install Astaro came up with the message of only 1 NIC card being present.  

What can I do? I just can't figure this one out here!


This thread was automatically locked due to age.
  • Whats does 
     mean? Which version of the linux kernel with which driver module?
    Which card will be detected by ASL?

    [ 22 November 2001: Message edited by: lop ]

  • Basically this meant that on the machine I had Red Hat Linux 7.2, and the installer saw all 3 of the NIC cards with no drivers required.

    Over the last 24 hours I swapped in an AsanteFast 10/100 card - it was not seen.

    Finally I swapped in one of the D-Link 4 port cards - it was seen and installed fine, but I'd really like to use the 4 port card in my server like I intended... is it just that the Dlink DFE-538-TX cards don't work??
  • asl-hardware.txt does not list your Dlink DFE-538-TX. 
    Perhaps it will be usefull for the guys from astaro if you post the PCI id of this card (/proc/pci and /proc/bus/pci/devices) and the drives used by Red Hat Linux 7.2.

    [ 22 November 2001: Message edited by: lop ]