This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

3 NIC detected, but only 1 works

I just installed astaro 2.0
My 3 HP j2585B NIC where correctly detected during the installation, but after the reboot I can only configure the first one.

When I type ifconfig eth1 I get :
eth1: error fetching interface information: Device not found

This thread was automatically locked due to age.

0 oliver.desch over 23 years ago

Hi roberto,

please post /etc/modules.conf.

read you
o|iver
Cancel
Vote Up 0 Vote Down

Cancel
0 roberto_01 over 23 years ago in reply to oliver.desch

Hello Oliver,

I tried to edit the modules.conf file. There was only one line (eth0). I tried to add two line for the other NIC as one user suggested but it didn't change anything.

Eventually I decided to replace the 3 HP NIC by 3 3COM Boomerang boards. And it works fine ...

Robert.
Cancel
Vote Up 0 Vote Down

Cancel