This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Accessing the Web Interface on a new Install

First off, I'm a Linux newbie.  Having said that, here's my issue:

I just installed ASL on a Dell Poweredge 350.  It's got 2 internal NICs and an Intel card with 2 interfaces for a total of 4 ethernet connections.

The install appears to go fine, the box boots up, I get e-mail from it (No psd-watch running! Restarting /sbin/init.d/psd-watch Astaro Security Linux  1.811), and I can ping inside and outside hosts.

I cannot however, connect to the web interface to continue the setup.  I'm using IE 5.5 on Win2k, and all I get is a "page cannot be displayed" error.

Please help!

Thanks in advance.

-Bob.

This thread was automatically locked due to age.

0 bbermingham over 23 years ago

Nevermind, I'm just an idiot. I was forgetting to add the 's' onto http when I was typing it into my browser.
Cancel
Vote Up 0 Vote Down

Cancel
0 micio over 23 years ago in reply to bbermingham

hi bbermingham,
another thing:
don't install I.E. 5.5 on win2k it causes a
lot of conflicts on.
The last good is I.E. 5.01 (the one with service pack 2).
ciao
Cancel
Vote Up 0 Vote Down

Cancel