This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

WLAN to Bridge

Hallo,

ich habe eine SG und da zwei Netze.

ETH0 = Verwaltungsnetz

ETH4 = Produktionsnetz

Wenn ich nun einen WLAN einrichte und da unter Client Traffic "Bridge to LAN" zuordne, wo kann ich denn in der UTM sagen auf welches LAN er sich bridgen soll (Verwaltung oder Produktion)

Am Ende möchte ich 3 SSID's

- Verwaltung
- Produktion
- Gäste

Gruß, Herry

This thread was automatically locked due to age.

Top Replies

jprusch over 4 years ago +1

Hallo, das bestimmt man indirekt, in dem man 1. unter "Wireless Protection/Global Settings/Allowed Interfaces" das richtige (physische) Interface angibt. 2. den Access Point physisch in das "richtige…

Parents

0 FormerMember over 4 years ago

Hi Akcent,

Thank you for reaching out to the Community!

When you configure the bridge to the AP LAN wireless network, the wireless network will be bridged to the LAN interface that the AP is connected to.

Thanks,
Cancel
Vote Up 0 Vote Down

Cancel
0 jprusch over 4 years ago in reply to FormerMember

Too late, I was faster :-)

Mit freundlichem Gruß, best regards from Germany,

Philipp Rusch

New Vision GmbH, Germany
Sophos Silver-Partner

If a post solves your question please use the 'Verify Answer' button.
Cancel
Vote Up 0 Vote Down

Cancel
0 FormerMember over 4 years ago in reply to jprusch

Hi jprusch,

I will mark your reply as a verified answer. :)

Thanks,
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 FormerMember over 4 years ago in reply to jprusch

Hi jprusch,

I will mark your reply as a verified answer. :)

Thanks,
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data