Good Afternoon,
We have two sites and have recently had hot standby router installed by BT so your typical triangle setup.
I have been taksed to get a second UTM and confiure both for automatic failover the IP address info from BT is below.
The current UTM at our Primary site is configured thus
WAN - IP : 194.72.126.66 GW : 194.72.126.65
LAN - IP 10.1.1.10
DMZ - 192.168.0.10
I suspect I need to add static routes for the additional routes below can anyone give me some pointers on how to configure both the old UTm and what I need to do on the new one ie what IP and GW do I assign the new UTM?
194.72.126.64 255.255.255.224
194.72.126.74<<used on primary router
194.72.126.75<<used on V1 router
194.72.126.65<< HSRP standby address and the gateway for you to point to from both devices
194.74.139.64 255.255.255.240
194.74.139.66<<< used on primary
194.74.139.67<<used on V1
194.74.139.65<<< HSRP standby address and the gateway for you to point to from both devices
New range configured:
86.188.208.208 255.255.255.240
86.188.208.210>>used on primary
86.188.208.211>>used on V1
86.188.208.209>> HSRP standby address and the gateway for you to point to from both devices
This thread was automatically locked due to age.
