This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

[INFO-142] OSPF daemon (ospfd) not running - restarted

I get this fun little notification about once an hour since turning IPv6 on.. As far as I can tell the UTM 9 doesn't even support OSPFv3 (IPv6 version of OSPF), wonder why turning IPv6 support on while OSPFv2 was running would break it.. Hmm...

Regards,

Adam Tyler

This thread was automatically locked due to age.

0 BAlfson over 8 years ago

Please let us know what Sophos Support has to say about this, Adam.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel
0 AdamTyler over 8 years ago in reply to BAlfson

No support on this particular deployment unfortunately, just the free home license. Incidentally, these messages seemed to stop after monkeying with the OSPF config some. I can't say exactly what I did that changed the behavior, but it had to do with removing and adding interfaces in the "Dynamic Routing (OSPF)>Interfaces" screen. Will let you know if I run across it again.
Cancel
Vote Up 0 Vote Down

Cancel