Hello,
I have some odd issue with sending out mail.
I built a basic VM machine of UTM 9.407-3 on ESXi 5.5. Basically has all the default firewall rules and almost no other configuration.
Web pages / surfing works. I can pull in e-mail via pop3, but can not send out by smtp.
Using Thunderbird mail client
pop on port 110
outgoing is using GoDaddy - smtpout.secureserver.net on port 465 with SSL/TLS.
Now the physical UTM machine all works fine. (it is not apples to apples so I can not just upload a config and forget about it) I am using everything transparent on both, so the UTM is to just pass everything along and out.
The physical machine is heavily customized for vlans but it is also using transparent mode, but I can send / receive mail fine. The VM machine of UTM is basically an out of the box default install that has the default mail rule of local / internal LAN out to any with all the default mail protocols set as configured by the wizard. I would think this would just let the mail go.
It has to be something very obvious and stupid I must be over looking. Looking at the settings for mail and outgoing mail from the internal network I can't see what setting is off or needs to be set. The VM is a very clean fresh install at basically the wizard defaults. Firewall rules as set by wizard should let it all go.
I switch between the VM and the actual hardware unit to test and can not have them up at same time.
Any suggestions on what to check and set or not set?
Chad
This thread was automatically locked due to age.