Thread Info
  • State Suggested Answer
  • Locked Locked
  • Replies 4 replies
  • Answers 1 answer
  • Subscribers 4 subscribers
  • Views 6032 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DNS Best Practices configuration question

TYSONDUNCAN

DNS Best Practices question https://community.sophos.com/kb/en-us/120283

In a network where the Sophos UTM is the DNS server for the PC's (192.168.0.1) and the AD is controlled by a windows server (192.168.0.3) my question is how to setup the "Request Routing" tab? Below is a screen shot showing the reverse DNS pointed to the Sophos UTM 192.168.0.1 and the Domain rlp-1201.lcoal pointing to 192.168.0.3. PC names are not being populated in the web reports, I am only getting the PC IP addresses.

Any suggestions and comments would be greatly appreciated.

my apologies if this is a silly question, I'm a bit of a noob



This thread was automatically locked due to age.
Parents
  • 0

    I've stopped looking at that KB because it's not as updated as the one from which it was plagiarized.  Compare your setup to DNS best practice and don't forget to insert the picture you mentioned. [;)]

    Since you have a WinServer, best practice for DHCP is to have it done by the Windows box instead of by the UTM.

    Cheers - Bob

Reply
  • 0

    I've stopped looking at that KB because it's not as updated as the one from which it was plagiarized.  Compare your setup to DNS best practice and don't forget to insert the picture you mentioned. [;)]

    Since you have a WinServer, best practice for DHCP is to have it done by the Windows box instead of by the UTM.

    Cheers - Bob

Children