This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

First Time Astaro Home Questions

Hello, I am planning on building an Astaro security appliance to place in my home network. I'm new to the software, but I've been told it is a bit easier to get set up and running than things like PfSense. 

I'm planning to just have the device sit on the network as a gateway, and have a Layer 3 switch do all my routing, vLANs, etc. I know the hardware configuration can assign DHCP, but can the appliance be used as a gateway? 

I would like to replace my router essentially and just have this run on top of my network handling incoming and outbound traffic, while the layer 3 switch does most of the work. Is that possible with the Home license version? 

I am planning on installing this on a blade server, so processing power, ram usage, etc shouldn't be a problem.


This thread was automatically locked due to age.
Parents
  • Hi Oxide_44 and welcome to Astaro.org community.
    Astaro Home (Sophos now) is almost a full version of UTM (apart some message customization and few things).
    You can manage up to 50 ip. 
    You can run it in bridge mode or routing mode. You can create and manage up to 4095 VLANs and many more features.
    Pfsense is a good product but Sophos is an UTM and integrate already many features that are very hard to integrate with Pfsense.
    Enjoy your Sophos installation.
    Regards, 

    Luk
Reply
  • Hi Oxide_44 and welcome to Astaro.org community.
    Astaro Home (Sophos now) is almost a full version of UTM (apart some message customization and few things).
    You can manage up to 50 ip. 
    You can run it in bridge mode or routing mode. You can create and manage up to 4095 VLANs and many more features.
    Pfsense is a good product but Sophos is an UTM and integrate already many features that are very hard to integrate with Pfsense.
    Enjoy your Sophos installation.
    Regards, 

    Luk
Children
No Data