Hi,
I'm looking for some guidance on the correct way to setup the UTM with a Layer 3 switch that has ip routing enabled.
HP Procurve Switch setup:
-vlan 100 - 192.168.100.1/24
-vlan 110 - 192.168.110.1/24
-vlan 120 - 192.168.120.1/30 (port 1)(UTM)
-Default route - 192.168.120.2 (UTM interface)
UTM scenario 1:
-HP Procurve switch port 1 connected to UTM (untagged)
-Create 1 interface - 192.168.120.2/30
-Create network definition - 192.168.100.0/24
-Create network definition - 192.168.110.0/24
-Add a static route - 192.168.100.0/24 -> 192.168.120.1
-Add a static route - 192.168.110.0/24 -> 192.168.120.1
-Add firewall, masquerading rules, etc. for all the networks
UTM scenario 2:
-HP Procurve switch port 1 connected to UTM (tagged vlan 100, vlan 110, vlan 120)
-Create Ethernet vlan interface - vlan 100 - 192.168.100.2/24
-Create Ethernet vlan interface - vlan 110 - 192.168.110.2/24
-Create Ethernet vlan interface - vlan 120 - 192.168.120.2/30
-Add firewall, masquerading rules, etc. for all the interfaces
Any guidance would be much appreciated.
Thanks!
This thread was automatically locked due to age.
