This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

The general Astaro configuration

Hi all,

Now I have 1 Switch + 1 Astaro + 1 Load Balancer device. Switch-Layer 3 is including:

- Two vlans (2-3 ) serving for end-users, servers...

- Create one more vlan (ex: vlan 4 on SW-L3) and set ip 192.168.4.x and then connect this port to one ethernet port on Astaro (ex: IP 192.168.4.x)

- All vlans on the switch have been routed (using Inter vlan routing feature).

- Create one Default Route on Switch - L3 points to the Astaro's ethernet port we have told the above

I want to ask that how the rules (firewall rule, static route, nat...) can i configure on this Astaro to allow the internal vlan's users to connect the Internet?

P/S: The Astaro have one interface is connecting to the Load balancer device(with many internet lines)

Grateful thank

This thread was automatically locked due to age.

Parents

0 BAlfson over 10 years ago

If I follow your explanation, Thuy, it seems that you have a good plan. Remember that the 'Destinations' in Firewall rules are IPs and that Routing is, in essence, Layer-2.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel
0 diemthuy over 10 years ago in reply to BAlfson

Hi,

I have a problem with the 'Destination' when I select the 'Destination' with Inside LB's IP not access the internet and now using the 'Destination' with 'Any' is fine.

Thanks.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 diemthuy over 10 years ago in reply to BAlfson

Hi,

I have a problem with the 'Destination' when I select the 'Destination' with Inside LB's IP not access the internet and now using the 'Destination' with 'Any' is fine.

Thanks.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data