So I am testing out the Sophos UTM and seeing if it can replace my Untangle, however I am not sure how to set it up right.
With Untangle, I go ISP Modem-->Sonicwall-->Ext Port on UT
Then, Int Port on UT-->8-Port Switch
Where SW is 192.168.1.1, UT is .254, and a server connected to 8Port switch does DHCP.
During UT installation, you specify to set it in Trans. Bridge mode instead of router mode and the Int. interface gets bridged to the Ext. interface. Everything is golden.
I am trying to figure out how to do the same thing on the Sophos UTM. I want to keep my 192.168.1.x range and basically just replace the UT with the Sophos box.
Do I need to bridge the two interfaces(Int and Ext)? Or just specify a static 192.168.1.x address for the Ext., then do DHCP for the int. one?
Sounds incredibly noobish, but I couldn't reach the internet when trying that way. Thanks.
This thread was automatically locked due to age.
