This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Allow Specific Connections

I am trying to setup our Polycom unit to connect properly to a company for video conferencing.

Below are the specifics that the company provided me and I am looking for some guidance on how to properly set everything up from within the SOPHOS router...

TCP 80/443 HTTP/HTTPS from client to Fuze web services

TCP 1720, 60,001 - 65,000 H.323 telepresence signaling*

UDP/TCP 3478 (STUN/NAT) traversal for video

UDP 5060 (SIP) signaling for video and VoIP

UDP 50,000 - 60,000 RTP for VoIP and video conferencing

This thread was automatically locked due to age.

Parents

0 vilic over 10 years ago
This was my solution for a client with Polycom system (after searching and reading a lot of forum posts with similar problems or questions):

Additional IP address on WAN interface.
DNAT rule.
SNAT rule.

Try first with ANY to eliminate service definition problems.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 vilic over 10 years ago
This was my solution for a client with Polycom system (after searching and reading a lot of forum posts with similar problems or questions):

Additional IP address on WAN interface.
DNAT rule.
SNAT rule.

Try first with ANY to eliminate service definition problems.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data