This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

backup restore

HEllo all,

I'm facing a little problem with my astaro security gateway 8 that i stopped using for 1 year. now i need to turn it on again as my new home setup is ok.

problem : 1 interface (internal) looks down.... can't access it ... and looks like my admin password for command line is not working also .... and i can't access grubb menu by pressing ESC !!!! a total mess !!!

so i have a Good backup file here with me and i would like to use it but as it is a security gateway 8 can i use it on a fresh UTM 9 install ?

Flo

This thread was automatically locked due to age.

Parents

0 apijnappels over 11 years ago

Could it be the interface is configured as a VLAN interface and the switch you're connnecting it to now is not configured likewise?
I do think that when this is the case the switch LED should blink however....

Managing several Sophos UTMs and Sophos XGs both at work and at some home locations, dedicated to continuously improve IT-security and feeling well helping others with their IT-security challenges.

Sometimes I post some useful tips on my blog, see blog.pijnappels.eu/category/sophos/ for Sophos related posts.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 apijnappels over 11 years ago

Could it be the interface is configured as a VLAN interface and the switch you're connnecting it to now is not configured likewise?
I do think that when this is the case the switch LED should blink however....

Managing several Sophos UTMs and Sophos XGs both at work and at some home locations, dedicated to continuously improve IT-security and feeling well helping others with their IT-security challenges.

Sometimes I post some useful tips on my blog, see blog.pijnappels.eu/category/sophos/ for Sophos related posts.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data