This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

backup restore

HEllo all,

I'm facing a little problem with my astaro security gateway 8 that i stopped using for 1 year. now i need to turn it on again as my new home setup is ok.

problem : 1 interface (internal) looks down.... can't access it ... and looks like my admin password for command line is not working also .... and i can't access grubb menu by pressing ESC !!!! a total mess !!!

so i have a Good backup file here with me and i would like to use it but as it is a security gateway 8 can i use it on a fresh UTM 9 install ?

Flo

This thread was automatically locked due to age.

Parents

0 BAlfson over 11 years ago

You should be able to use an 8.312 to restore to V9. Probably, you can use older backups, but that will be less reliable. I would install ftp://ftp.astaro.com/UTM/v9/software_appliance/iso/asg-9.111-7.1.iso instead of one of the 9.2 ISOs and then Up2Date from there. If you have a really old backup, you might want to install 8.311, restore to that, Up2Date to 8.313 and make a new backup before installing V9.111 and restoring to it.

Sometime, in a new version, the order of the interfaces can change, so try both to see which is Internal.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 BAlfson over 11 years ago

You should be able to use an 8.312 to restore to V9. Probably, you can use older backups, but that will be less reliable. I would install ftp://ftp.astaro.com/UTM/v9/software_appliance/iso/asg-9.111-7.1.iso instead of one of the 9.2 ISOs and then Up2Date from there. If you have a really old backup, you might want to install 8.311, restore to that, Up2Date to 8.313 and make a new backup before installing V9.111 and restoring to it.

Sometime, in a new version, the order of the interfaces can change, so try both to see which is Internal.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data