This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

UTM 9 login problem

I have just installed UTM 9.1 on a spare PC, when it boots up it goes though a load of messages and then ends up at a login prompt ? but I do not have a login? where do I get the info so I can login please

This thread was automatically locked due to age.

0 teched_01 over 11 years ago

The installation should have directed you to https://192.168.1.1:4444/ (or another IP depending upon how the UTM was configured) for WebAdmin.

The username root with a blank password might work at the post-install console - but the web interface is the intended primary interface.
Cancel
Vote Up 0 Vote Down

Cancel
0 kenhut over 11 years ago

well that sorter worked thanks, i have now set up a login password(via root) but I am now at
host:/root # how do I get into the browser to go to that webpage?
Cancel
Vote Up 0 Vote Down

Cancel
0 teched_01 over 11 years ago

Use the browser on another computer.

Quick Start Guide:
http://www.sophos.com/en-us/medialibrary/PDFs/documentation/sophosutmsoftwarewebadminqsgen.pdf
Cancel
Vote Up 0 Vote Down

Cancel
0 kenhut over 11 years ago

this is to much hassle, I get into network sharing but then what? the guide does not take you throgh the steps required, I do not use linux but the guide assumes you know how to use it.

I think I will give up on this project as I will drive you nuts trying to guide me.
Thanks for your help tho
Cancel
Vote Up 0 Vote Down

Cancel