This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

runaway ipv6_watchdog?

On our Sophos UTM 9.1 system (ASG120 hardware), with a partial IPv6 configuration (I am getting IPv6 address from the VDSL router, but haven't set up anything much more than that), the ipv6_watchdog is in some kind of busy-loop using 100% of one of the CPUs:
[FONT=Lucida Console][SIZE=1]

top - 11:48:14 up 16 days, 42 min,  1 user,  load average: 1.69, 1.60, 1.44
Tasks: 140 total,   2 running, 136 sleeping,   0 stopped,   2 zombie
Cpu(s): 50.8%us,  0.5%sy,  0.0%ni, 46.6%id,  2.2%wa,  0.0%hi,  0.0%si,  0.0%st
Mem:   2048196k total,  1892248k used,   155948k free,   384248k buffers
Swap:  1048568k total,        0k used,  1048568k free,  1193888k cached

  PID USER      PR  NI  VIRT  RES  SHR S   %CPU %MEM    TIME+  COMMAND
 4026 root      20   0  1908  548  444 R    100  0.0  13254:19 ipv6_watchdog
 3044 root      20   0  4292 1688  880 S      1  0.1  73:46.57 irqd
[/SIZE][/FONT][FONT=Lucida Console][SIZE=1]
[/SIZE][/FONT]
Running strace on the ipv6_watchdog process shows no system calls (it is in a pure CPU loop).

I looked in the logs around the time the overall CPU bumped up to >50% (this was about a week ago, according to the CPU graphs in the daily report), but found nothing there.

A reboot seems to have cleared the problem (for now), but I'm wondering if anybody else has seen this, or has any suggestions to prevent it from happening again.


This thread was automatically locked due to age.
Parents Reply Children
No Data