This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Using Command Line Interface\SSH to create new rules on

Hello!
I have recently installed UTM 9 and have a question:
I There a way to make configuration to the system via command line interface \ ssh?
where can i find more information on the subject?

More specifically - i am trying to add firewall rules (the ones available through Network Protection -> Firewall -> New Rule...

Thanks!

This thread was automatically locked due to age.

Parents

0 samy_01 over 11 years ago

You can use the shell, but it is not offically supported and you would void the warranty. For a list of commands check this post here: https://community.sophos.com/products/unified-threat-management/astaroorg/f/51/t/21326
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 samy_01 over 11 years ago

You can use the shell, but it is not offically supported and you would void the warranty. For a list of commands check this post here: https://community.sophos.com/products/unified-threat-management/astaroorg/f/51/t/21326
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 trashcan410 over 11 years ago in reply to samy_01

Thanks for the Answer!
Could you please point me to the command with the "create firewall rule" there? i'm having trouble finding it...[:S]
Cancel
Vote Up 0 Vote Down

Cancel