This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Routing through Firewall

Hello,

I am trying to configure a network, I set ASG8 as a Firewall and as the default gateway of my applications.

As you can see, I have 3 Vlans.
VLAN 2 ping VLAN 120
VLAN 120 ping VLAN 2
(without configuration)

VLAN 2 + VLAN 120 ping VLAN 96.
(configuration)

But my problem, VLAN 96 doesn't ping VLAN 2/120.
I tried "Policy route", but it didn't work, I don't know how set the best configuration.
This is not my router configuration, I'm sure, because when I changed the default gateway of my Client in VLAN 2 on G0/0, I could ping it with VLAN 96.

Thanks
Regards

This thread was automatically locked due to age.

Parents

0 RFCat_vk_01 over 12 years ago

Hi,
It will be something quite simple like ICMP is not enabled in network protection.

Ian
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 RFCat_vk_01 over 12 years ago

Hi,
It will be something quite simple like ICMP is not enabled in network protection.

Ian
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 FlorianVN over 12 years ago in reply to RFCat_vk_01
Hello,

Thanks, but I'm sorry ICMP is already enable.
I found why it didn't work, I've put a bad default gateway.
Source Interface : Any (eth1, eth2 firewall)
Source Network : VLAN 2 + 120
Service : Any
Destination network : VLAN 96
Gateway : Router PPP G0/0

But...
Now I can't ping my Firewall ports from the VLAN96, but I can ping VLAN 120 & 2.
And I would like to have an access on Internet without disturb my configuration if is possible.
Cancel
Vote Up 0 Vote Down

Cancel