This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

IPv6 and PPPOE issue

Hello,

I want to test something on my astaro with IPv6. So I read, how to get a IPv6 address from my ISP, and I do so.
But there is something strange.
If I have IPv6 enabled. Now I edit my PPPOE interface and enable "ipv6 gateway". But I get only a v4 address and gateway.
I disalbe "ipv4 gateway" and get an IPv6 address and gateway.
But I want both at the same time.

Is this an issue of the 8.103?

regards

This thread was automatically locked due to age.

Parents

0 da_merlin over 14 years ago

You can see the RA prefix by executing "rdisc6 ppp0" on the command line.
But if this Prefix is not static, you have to manually reconfigure the ASG
on each disconnect...

Cheers
Ulrich
Cancel
Vote Up 0 Vote Down

Cancel
0 wogman over 13 years ago in reply to da_merlin

Hi all,

Is this issue still on the radar? Will we see dynamic IPv6 addressing on PPPOE in the next version?

I'm still keen to try out the dual stack option now my ISP has it in full production. [:D]
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 wogman over 13 years ago in reply to da_merlin

Hi all,

Is this issue still on the radar? Will we see dynamic IPv6 addressing on PPPOE in the next version?

I'm still keen to try out the dual stack option now my ISP has it in full production. [:D]
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data