This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Web Application Firewall - how to setup in bridge mode?

hi guys,

i'm new here. trying to setup web application firewall one website. currently the firewall is running in bridge mode. any can help how to do this?

firewall : 202.***.***.13
webserver : 202.***.***.20

i've setup the "real websever" and the virtual webserver. i can view the website, but seem the traffic wasn't go through the WAF. even the graph is not showing anything. what am i missing here?

This thread was automatically locked due to age.

0 BAlfson over 14 years ago

Hi, akmal, and welcome to the User BB!

is 202.***.***.13 the default gateway for the webserver? Is .13 also the address you're using to reach the webserver?

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel
0 akmal over 14 years ago

default gateway is 202.***.***.1 .. the address that i use to reach the webserver is .20
Cancel
Vote Up 0 Vote Down

Cancel
0 BAlfson over 14 years ago

If you want to use the WAF, you have to route the traffic through it instead of avoiding the Astaro.

Cheers - Bob
Cancel
Vote Up 0 Vote Down

Cancel