This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

vnc problem

hello,

I have one server(w/ private ip) resides behind my asg320.the vnc server installed on that particular machine.
I create a DNAT rule w/c I could access via vnc when Im out the office.
My problem as of now I got an error "Failed to connect the server".

I already opened ports (5800,5801,5900,5901) but still failed to access via vnc remotely.
Accessing the said server locally via vnc has no problem.

Need additional suggestions if any.

Thanks

This thread was automatically locked due to age.

Parents

0 BAlfson over 15 years ago

Barry, I think DNAT for a service group works - just like it did before V7. I bet his problem is that he's using a network definition for the traffic destination instead of the interface address.

Cheers - Bob
PS Asgnewbie, if that's not the case, please show a picutre of your DNAT.
Cancel
Vote Up 0 Vote Down

Cancel
0 asgnewbie over 15 years ago in reply to BAlfson

pls see attached file for your reference
- DNAT.jpg
- View
- Hide
Cancel
Vote Up 0 Vote Down

Cancel
0 asgnewbie over 15 years ago in reply to asgnewbie

any update?
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 asgnewbie over 15 years ago in reply to asgnewbie

any update?
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data