Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 8 replies
  • Subscribers 3 subscribers
  • Views 1918 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Astaro ASG 7.5.02 and T1 Setup

bsawyers
Need help setting up my Astaro ASG to work with t1 and Cisco 2811 router?


This thread was automatically locked due to age.
Parents
  • 0
    Hi, the default packet filter policy is to DROP... you'll need to allow the desired traffic.

    A simple setup would be
    Source: LAN
    Dest: ANY
    ALLOW

    Barry
  • 0 in reply to BarryG
    I'm not sure you even need the extra router; the Astaro can take the place of both the ASA and the router, unless you are using that router for multiple WAN / LAN networks, etc.  YOu can place one interface on the outside (using the public IP), and the internal network and any DMZs on other interfaces or VLANs, and just use the NAT/DNAT/SNAT/MASQ function of the Astaro to connect the inside to the outside.
Reply
  • 0 in reply to BarryG
    I'm not sure you even need the extra router; the Astaro can take the place of both the ASA and the router, unless you are using that router for multiple WAN / LAN networks, etc.  YOu can place one interface on the outside (using the public IP), and the internal network and any DMZs on other interfaces or VLANs, and just use the NAT/DNAT/SNAT/MASQ function of the Astaro to connect the inside to the outside.
Children
No Data