This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Server Load balancing solution for disaster recovery?

Hi,
we want to setup a disaster recovery solutions for our web server.
We have 2 sites connected with vpn and 1 web server in site1, now we want to create a copy of this server in site2.
We are looking for a device that is able to take the web server queries and load balance them to the web server in site1 and site2, in case of a failure of 1 of them all the the traffic should be redirected to the one functioning automatically.
Both server have public ip address.
Is astaro able to accomplish this solution?
Thank you.
Regards


This thread was automatically locked due to age.
  • 'Network Security >> Server Load Balancing'

    From the User's Manual:
    Example: Suppose that you have two HTTP servers in your DMZ with the IP addresses 192.168.66.10 and 192.168.66.20, respectively. Assumed further you want to distribute HTTP traffic arriving on the external interface of your firewall equally to both servers. To set up a load balancing rule, select or create a host definition for each server. You may call them http_server_1 and http_server_2. Then, in the Create New Load Balancing Rule dialog box, select HTTP as Service. In addition, select the external address of the firewall as Virtual Server. Finally, put the host definitions into the Real Servers box. 


    Cheers - Bob
  • Thank you Bob. 
    Do you know if Astaro is able to recognize if one of the server is down and redirect all the traffic the one online?
    Cheers.
    Andy
  • Andy, Andy, Andy... [:D]

    That is clearly explained in the manual, and a glance at the configuration of page would confirm that.

    Cheers - Bob
  • oopppsss, sorry you're right..
    Thank you again for your support.
    Cheers.
    Andy