This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Asg 425 failover

Hi Astaro Users,
Im a newbie in astaro,
Kindly help me Im currently using ASG 425 ver 7.402.
Here's my current setup,WAN==>ASG 425(port1),(port0)==>internal network.
Everything works fine.My question is how do I configure my ASG 425 my act as Failover between my 2 IP's.Im going to connect my 2nd ISP to Port 4.
Please help me asap. Thanks [:S]

This thread was automatically locked due to age.

0 BAlfson over 16 years ago

There are several possible solutions. Are you using the SMTP Proxy? Are you using the HTTP Proxy? What are the speeds of each WAN connection?
Cancel
Vote Up 0 Vote Down

Cancel
0 Cath over 16 years ago in reply to BAlfson

Hi ASGnewbie and welcome to the forum!

For setting up multiple ISP links and failover you will be best served by following the Uplink/Multipath failover guides from the astaro kb.

Article links from www.astaro.com/kb:

305161 Multipath and Uplink Failover Guide
http://portal.knowledgebase.net/display/2n/kb/article.asp?aid=305161

303438 How to automatically failover WAN links
http://portal.knowledgebase.net/display/2n/kb/article.asp?aid=303438
Cancel
Vote Up 0 Vote Down

Cancel
0 asgnewbie over 16 years ago in reply to Cath

Hi Guys,
Many thanks to all who replied.
Highly appreciated your effort.
Anyway, back to my query I solved this morning.What I did just configured my 2 WAN interfaces w/ correct ip addresses,subnet mask,default gateway and dns.after that enable the uplink option used the failover link and select my primary isp in that option.There it goes everything i missed to configured paid of. Many thanks Guys till new queires arise.Ciao!
Cancel
Vote Up 0 Vote Down

Cancel