This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

cannot change webadmin port from 4444 to 443

Hi,

either with the webadmin console or with ssl direct on the firewall i get an error that the value 443 isn't correct. I've updated from 6.3 to 7.2
On v6 the webadmin port was 443

How can i change back to 443 in v7?

regards

This thread was automatically locked due to age.

0 ClausP over 17 years ago

1.) Change port of the end user portal => /Management/End-User Portal/Advanced/
2.) Change webadmin port => /Management/WebAdmins Settings/
Cancel
Vote Up 0 Vote Down

Cancel
0 mamema over 17 years ago in reply to ClausP

Hi

So i discovered the End-User-Portal, thank you for that. But it was disabled and enabling and changing the port didn't help.
Still get the error "One of the values you entered is syntactically incorrect"
when i try to change the webadmin port.

regards
Cancel
Vote Up 0 Vote Down

Cancel
0 BrucekConvergent over 17 years ago in reply to mamema

I believe the port has to be set to a value greater that 1024.
Cancel
Vote Up 0 Vote Down

Cancel
0 mamema over 17 years ago in reply to BrucekConvergent

I believe the port has to be set to a value greater that 1024.

hmm, must be an new "feature" then. On v6 it was Port 443
Cancel
Vote Up 0 Vote Down

Cancel
0 BrucekConvergent over 17 years ago in reply to mamema

It was probably done that way to prevent admins from inadvertently locking themselves out of Webadmin when they setup a DNAT rule for an internal SSL website, etc...
Cancel
Vote Up 0 Vote Down

Cancel