This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

HA work not properly

Hi

My Astaro (v7.0009) work in cluster-" HA/Cluster is active in mode HA with 2/2 nodes"[8-)] .They are connected with cross cable. I don't know, is there (cabling) problem exactly, but in some cases, devices changing roles (slave/master and backward) with each other with out clear reason.
May the the connection over the switch would be helpful.[:S]
Have any ideas?[:S]

Sorry-poor english [:$]

Regards,
Gytis- Lithuania.
Thanks!

This thread was automatically locked due to age.

0 James Bourne over 17 years ago

Active/active? Active/passive? On your own hardware or an ASG? HA should work with a cross over. 10/100BT or 1000BT interface? Are the interfaces MDIX so you don't need a X-over? If you are using a standard CAT-5 X-over on 1000BT you might run into problems due to all four wire pairs being used on 1000BT. Construct the correct X-over, or force speed/duplex or use a switch? For example: http://www.pccables.com/02303.htm

Anything in Logging -> View log files -> High availability?
Cancel
Vote Up 0 Vote Down

Cancel
0 BarryG over 17 years ago in reply to James Bourne

In my experience, a crossover cable is not necessary with most gigabit capable NICs, even if only one of the 2 computers has one.

Barry
Cancel
Vote Up 0 Vote Down

Cancel
0 James Bourne over 17 years ago in reply to BarryG

I see 7.010 also fixes an HA issue ...

Fix [6525]: Corrupt databases in HA/Cluster environment
Cancel
Vote Up 0 Vote Down

Cancel