This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

I cannot Delete an additional IP on an Interface

I recently upgraded my spare ASG320 from 6.303 to 7.005
The import of the V6 backup went well. Before I can bring it up on the network I need to delete a few of the alias's I have on eth7.
The only problem is there is no delete or edit buttons under additional addresses

Can someone help

Mark

This thread was automatically locked due to age.

Parents

0 Scott_Klassen over 18 years ago

Unfortunately, it's a known issue with the V6 > V7 config conversion process. No known fix that I've seen here on the boards. The only way I've heard to avoid this pitfall is to do a clean install of V7 and manually reconfigure everything from scratch, skipping the import of the V7 config file.

If you decide to go this route, do not use the standard iso for the upgrade, you'll need a special one since you have an appliance. You can find the correct image at ftp://sai7:rhasDoal9@ftp.astaro.de and you'll need an external USB CD-ROM. It's a fairly painless upgrade that on a 320 will take about 20 minutes according the the upgrade doc in the knowledgebase.

__________________
ACE v8/SCA v9.3

...still have a v5 install disk in a box somewhere.

http://xkcd.com
http://www.tedgoff.com/mb
http://www.projectcartoon.com/cartoon/1
Cancel
Vote Up 0 Vote Down

Cancel
0 mpjbell over 18 years ago in reply to Scott_Klassen

That completley sucks!
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 mpjbell over 18 years ago in reply to Scott_Klassen

That completley sucks!
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data