This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

5.010 NIC issue

My external NIC is a 3Com 3c905 100BaseTX [Boomerang].  I have two internal (Intel EtherExpress PRO/100+ Dual Port Adapter).

When I applied/installed the 5.010 update, the 3Com H/W "disappeared".  System itself sees the 3Com NIC card correctly but ASL does not.  I've rolled back to 5.09 and all works great.

In my troubleshooting I was frustrated as I was looking at the "Interface" as being down (Current Interface Status) but wasn't paying attention to the fact that ASL wasn't seeing the NIC at all (Hardware List - just below "Current Interface Status").

Any ideas?

This thread was automatically locked due to age.

Parents

0 omega over 21 years ago

We have a similar Problem here. After an update to 5.010 the Nics were
reordered which means that we had to switch cables. A 3com was used as one
of those nics.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 omega over 21 years ago

We have a similar Problem here. After an update to 5.010 the Nics were
reordered which means that we had to switch cables. A 3com was used as one
of those nics.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data