This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

mss 1452

I'm using astaro in japan.

MTU of PPPoE is not 1492 at the Japanese case.

For example, MTU of PPPoE that typical NTT goes in Japan is 1454.
It makes up its mind, and a parameter comes to deliver 1452 in the inside with DSL.sh.
Because of this, if proxy isn't used, some of the sites can't be seen.

It finally noticed that, and a parameter was revised.
Try so that you can input MTU on the Web screen, and cope with it so that variability may do the value of MSS, too.

This thread was automatically locked due to age.

0 bagira over 21 years ago

If you enable the "advanced options" on the network interface settings, you´ll find the mtu size settings on the WebAdmin
Cancel
Vote Up 0 Vote Down

Cancel
0 debizoh over 21 years ago in reply to bagira

That is the setup of NIC. It is not PPPoE.
Cancel
Vote Up 0 Vote Down

Cancel
0 SecApp over 21 years ago in reply to debizoh

He's got a point though; if you lessen the MTU of the NIC that goes out to your ISP, it might rediuce packet sizes pppoe is transmitting. Easy enough to try...
Cancel
Vote Up 0 Vote Down

Cancel
0 debizoh over 21 years ago in reply to SecApp

thanks for your reply.

Said meaning was understood.

First of all it is finished because DSL.SH itself which caused a trouble was rewritten.

Only, because it is FireWall which Astaro can be set up to very properly, as for Japan as well, it has the wish to have it spread a little more.

Tentatively, it thought whether you had better be able to set it up, and let me make remarks as a request.
Cancel
Vote Up 0 Vote Down

Cancel