This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Need Help! Reporting not working!

neo2048 over 21 years ago

Hi Everyone!

Can someone help me out? I just installed ASL 4.017 (fresh install) and strangely, I got no reporting.... Even after rebooting, waiting couple hour, generating traffic, I got 0% cpu utilisation... 0% network usage... etc...

can some one help me out? it's a plain, fresh new install with basic internet access rules and masquerading... is there something to do to trun on reporting????

thanks

Neo2048

This thread was automatically locked due to age.

Parents

0 William Warren over 21 years ago

I take it you mean the accounting? It has been said in earlier posts you have to generate enough traffic or accounting will not work..however the threshold for accounting to work has never been dfenined to my knownledge.....
Cancel
Vote Up 0 Vote Down

Cancel
0 neo2048 over 21 years ago in reply to William Warren

actually, I just want to see the CPU usage... and looking under reporting --> Hardware I got :

CPU Utilization
Maximum: 0% Average: 0% Current: 0%

samehing for RAM, Network usage and so on....

Do I need to turn on accounting in order to see those stats???

Neo2048
Cancel
Vote Up 0 Vote Down

Cancel
0 William Warren over 21 years ago in reply to neo2048

no you can go under hte reports section under hte hardware subsection to get all of those numbers..[:)]
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 William Warren over 21 years ago in reply to neo2048

no you can go under hte reports section under hte hardware subsection to get all of those numbers..[:)]
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 neo2048 over 21 years ago in reply to William Warren

???  hte report ???  I'm lost....

preaty new to astaro...  what you mean by hte reports? do I have to use the console? is it trough the menu?

when i go trough the admin menu...  click on reports then hardware, everything is at 0% all the time.....

seem that MRTG is not working at all!!!
Cancel
Vote Up 0 Vote Down

Cancel
0 neo2048 over 21 years ago in reply to neo2048

Found out what was wrong.... Actually, when doing the install, the date was wrong... and seem to completely messed the snmp log files....

since I played too much with the original MRTG conf file I had to re-install the whole software but normally, just removing the logs and restarting should have do the trick....

Neo2048
Cancel
Vote Up 0 Vote Down

Cancel