Thread Info
  • State Not Answered
  • Locked Locked
  • Replies 3 replies
  • Subscribers 3 subscribers
  • Views 813 views
  • Users 0 members are here
Options
Suggested
This discussion has been locked.
You can no longer post new replies to this discussion. If you have a question you can start a new discussion

locked out of webadmin

oat
Hi all,
I just installed a trial version of Astaro version4. The installation went fine. but after few configurations through  the webadmin, I got locked out. Thrice I have experienced this, thrice i had to re-install. Please does anybody have a permanent solution to this. I have gone through solution to similar prolems on the forum, none seems to solve my problem.

Thanks.   


This thread was automatically locked due to age.
Parents
  • 0
    Hi,

    I had a similar problem when I entered the following configs for my NICS.

    eth0 (Internal 1) - 10.10.0.1/255.255.0.0
    eth1 (Internal 2) - 10.11.0.1/255.0.0.0

    when I brought the NICs UP ASLv4 just  frooze and on reboot  no longer accepted my Webadmin password forcing me to re-install 06 times !! 

    Cheers

    Abi  
  • 0 in reply to Abi_01
    Hi Abi,

    this cannot work, 
    because your eth1 Subnet includes already the eth0 network.
    How should the system decide where to send your packets ?

    You need at least /16 (255. 255 .0.0) subnet for eth1

    Regards,
    Karsten  
Reply
  • 0 in reply to Abi_01
    Hi Abi,

    this cannot work, 
    because your eth1 Subnet includes already the eth0 network.
    How should the system decide where to send your packets ?

    You need at least /16 (255. 255 .0.0) subnet for eth1

    Regards,
    Karsten  
Children
No Data