This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

ASL 4.0 - system stops responding

     Hi,  Astaro 4.0 so far is a good product.   However, it will occasionaly stop responding to any traffic from outside.  I have 3 Dlink 530TX cards and I've read about the /etc/module.conf fix.  I'm currently running with 8139too as the driver name but it still locks up at the rate of once every 1 or 2 days and I can't find anything that stands out in the logs.   Any other suggestions would be greatly appreciated.
     One  a less serious note, I applied the 4.001 patch but the live logs still don't work (I'm running webadmin on port 8443).  Am I the only for whom this doesn't work even with the patch?

Boba

This thread was automatically locked due to age.

0 jfeller over 22 years ago

I have the same problem...
Every day Astaro stops responding and I can't login into the console. So I must hard reset the ASL Box and then it works fine for several minutes or sometimes for several days.

My hardware is:

Compaq DP 4000
PII 233 MHz
3,2 GB HD (IDE)
128 MB RAM
Tlan NIC on Board and a D-Link 580-TX

Where is the problem? Has anyone an idea?

Thanks jfeller
Cancel
Vote Up 0 Vote Down

Cancel
0 Deezel over 22 years ago in reply to jfeller

I had this too sometimes, but i never experienced it after the update to 4.001
Cancel
Vote Up 0 Vote Down

Cancel
0 PabloDiablo over 22 years ago in reply to Deezel

In the 4-5 weeks I'm using the new version, I had only once that the ASL hanged (on the internal NIC).
Cancel
Vote Up 0 Vote Down

Cancel