This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

Cannot connect to ASL 3.202 after adding second NIC

After installing ASL 3.202 I can access the system fine from the internal NIC, but after I add the configuration for my second NIC it seems to lock the system out from any sort of webadmin access. I can still log in if I'm sitting at the system.

This thread was automatically locked due to age.

0 Andy_01 over 23 years ago

might be a routing problem. do you have a default gateway on both interfaces??? you can change that in /etc/wfe/conf/itf.conf
Cancel
Vote Up 0 Vote Down

Cancel
0 dmmcfar over 23 years ago in reply to Andy_01

Yes I have a default gateway on both, The webadmin would load perfectly fine before I added the definition for the second NIC then it just stops.
Cancel
Vote Up 0 Vote Down

Cancel
0 Tmor over 23 years ago in reply to dmmcfar

im assuming u reinstalled the ASL software and reloaded a saved config file?
Cancel
Vote Up 0 Vote Down

Cancel
0 dmmcfar over 23 years ago in reply to Tmor

Even if I go from scratch it'll lock up after I add the second interface definition.
Cancel
Vote Up 0 Vote Down

Cancel
0 Andy_01 over 23 years ago in reply to dmmcfar

what i was saying is, don't enter gateways on both interfaces...
Cancel
Vote Up 0 Vote Down

Cancel
0 dmmcfar over 23 years ago in reply to Andy_01

OK I only entered a gateway on one of the NICs and still came up with the same problem.
Cancel
Vote Up 0 Vote Down

Cancel
0 Maurice over 23 years ago in reply to dmmcfar

Originally posted by dmmcfar:
OK I only entered a gateway on one of the NICs and still came up with the same problem.
Can you post your NIC configurations?
Also, have you checked cables/connections etc.?

Maurice
Cancel
Vote Up 0 Vote Down

Cancel
0 dmmcfar over 23 years ago in reply to Maurice

How much of my configuration do you need? Also I've already checked cables and connections. The reason I had to go to 3.202 is because the system is a K6-2/450 which in straight 3.2 won't do DHCP on a second NIC.
Cancel
Vote Up 0 Vote Down

Cancel
0 Maurice over 23 years ago in reply to dmmcfar

Originally posted by dmmcfar:
[QB]How much of my configuration do you need?[QB]
The NIC configuration should do.

Maurice

[size="1"][ 23 July 2002, 08:12: Message edited by: Maurice ][/size]
Cancel
Vote Up 0 Vote Down

Cancel
0 Tmor over 23 years ago in reply to Maurice

not much help i know, however i have one 3.202 with 6 interfaces/networks and everything works fine.

i am using standard Dlink, Intel, and 3com 10/100 cards.

basically troubleshooting is difficult without being able to reproduce the problem.
Cancel
Vote Up 0 Vote Down

Cancel