This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

After install on Raq4i Kernal Panic no init found...

Installed the flash update fine. (Had to mod go.sh slightly to get it to run without errors.

Restored the RAQ4i usig a CDrom with the iso. Seemed to go through all the processes of formatting / Installing ASL but when I reboot it just hangs on booting...

Serial Console says, after decompressing first stage kernal: Kernal panic no init found.

Any ideas?

Mount the drive and change files manually???

This thread was automatically locked due to age.

Parents

0 oliver.desch over 23 years ago

Neil,

what did you change?

Regards
Oliver
Cancel
Vote Up 0 Vote Down

Cancel
0 Neil Marshall over 23 years ago in reply to oliver.desch

I removed the spaces in the IF statements between the $variable the == and the "" in the go.sh script. I Did this in two cases, it seemed to work but then obviously the checksums had changed. I bypassed that bit of logic. I guess I should have recreated the checksums instead of bypassing...

Could that be why I get the kernel panic??? (Probably a stupid question but hey I'M STUPID)

Neil.
Cancel
Vote Up 0 Vote Down

Cancel
0 Neil Marshall over 23 years ago in reply to Neil Marshall

Forgot to mention that I got an error without making those changes to the go.sh script.

Neil.
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 Neil Marshall over 23 years ago in reply to Neil Marshall

Forgot to mention that I got an error without making those changes to the go.sh script.

Neil.
Cancel
Vote Up 0 Vote Down

Cancel

Children

No Data