This discussion has been locked.

You can no longer post new replies to this discussion. If you have a question you can start a new discussion

DNAT QUESTION....

I setup my dnat to forward all the http requests to my webserver... What I did is:

Extern(Extern NIC)-> HTTP -> Webserver->Http

when I try to open the browser and type http://"astaro external ip" the browser shows that it is trying to load the page, but stays there forever...... any sugestions?

This thread was automatically locked due to age.

Parents

0 comeanddance over 23 years ago

did you setup a rule in packet filter for this DNAT ???
Cancel
Vote Up 0 Vote Down

Cancel
0 giallu over 23 years ago in reply to comeanddance

And beside what comeanddance wrote, are you testing your connectivity from a IP NOT INSIDE the firewall?? if not chances are you're hitting the (in)famous address resolution problem.

Regards
Cancel
Vote Up 0 Vote Down

Cancel
0 xtech over 23 years ago in reply to giallu

Yes... if I acess my webserver inside the firewall by typing its IP on the browser works fine.... and I already setup a rule a for that dnat....
Cancel
Vote Up 0 Vote Down

Cancel
0 xtech over 23 years ago in reply to xtech

Any requests coming from outside are not working...
Cancel
Vote Up 0 Vote Down

Cancel
0 giallu over 23 years ago in reply to xtech

I think you should check the packet filter livelog, and report what you see when you try to access the webserver from the outside. That could help us to better understand what's going on at your side.

Regards
Cancel
Vote Up 0 Vote Down

Cancel

Reply

0 giallu over 23 years ago in reply to xtech

I think you should check the packet filter livelog, and report what you see when you try to access the webserver from the outside. That could help us to better understand what's going on at your side.

Regards
Cancel
Vote Up 0 Vote Down

Cancel

Children

0 xtech over 23 years ago in reply to giallu

Ok...will do that and let you know... thks....
Cancel
Vote Up 0 Vote Down

Cancel