[9.306-6] Wifi Nest / Dropcam

I loaded 9.306-6 this week as soon as I did both my Nest thermostat and Dropcam no longer connect back to their services. The Dropcam is stating it can't connect to Wifi, however I can ping it fine. I have 3 Nest smoke detectors and those are all working fine. Before loading this update they were working flawlessly. I have both an AP10 and a AP15. I don't see any traffic being blocked or filtered. I was just wondering if anyone has experienced a similar issue after loading this version, I am out of ideas at this point other than going back to the previous version. Any thoughts would be appreciated.

Thank you,
Brian

Parents

0 brianbednarz over 10 years ago

jamiemoney thank you for the information but that was not the issue on my side. It appears that the Dropcam and the Nest do not like the MTU setting of 1450 that happens when you go from 9.305-4 to 9.306. Changing the MTU on the interface back to 1500 allows the Dropcam and Nest to function normally.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 brianbednarz over 10 years ago

jamiemoney thank you for the information but that was not the issue on my side. It appears that the Dropcam and the Nest do not like the MTU setting of 1450 that happens when you go from 9.305-4 to 9.306. Changing the MTU on the interface back to 1500 allows the Dropcam and Nest to function normally.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data