I have a VM version of the Beta 9.165-15 installed to test and have a question about Web control feature in the End Point Protection section. I have enable the feature and enabled the feature in the group that my clients use. As you can see in the firewall settings attachment the web control is enabled but on the Client attachment it still shows Disabled. Are there both the same settings and is there an issue? I would have thought that the clients would update from the group they are assigned and turn that on.
Just to double check (the Doh! factor) - is the computer a member of "My Group". Is the Endpoint Group used by any of the Profiles?
Can you check if any errors have been logged, View Log Files, Endpoint Protection.
In order to check if this is a problem with Sync or a problem with Web Control, can you please try disabling Device Control. Wait for 30 minutes - if the client has not updated then it a problem with sync in general.
Note: There is nothing new in 9.2 that should affect this.
Also can you post your UTM ID (found on the Computer Management Advanced tab).
Just to double check (the Doh! factor) - is the computer a member of "My Group". Is the Endpoint Group used by any of the Profiles?
Can you check if any errors have been logged, View Log Files, Endpoint Protection.
In order to check if this is a problem with Sync or a problem with Web Control, can you please try disabling Device Control. Wait for 30 minutes - if the client has not updated then it a problem with sync in general.
Note: There is nothing new in 9.2 that should affect this.
Also can you post your UTM ID (found on the Computer Management Advanced tab).
