[9.080][CLOSED]Wireless Protection AP setup

Hi,
this issue has been raised in the Wireless Protection forum, but as the same wireless AP upgrade was applied in the this beta version and the current production version (assumption) I will continue.

Issue is in Australia we have channels 1 to 13 in the 2.4hgxz band.
AP10 and AP 30 no longer have channels 12 and 13 available to them.
AP 50 does.
My APs all show the country as Australia.

Ian

Parents

0 treskaan over 12 years ago

Hi Ian,
did the APs stream the channels 12 and 13 in a previous version of the beta in your region?? That would be indeed a bug as AP10 and 30 don't offer the channels 12 and 13 by design as we sell these APs in all regions.
Greetings,
Andreas
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 treskaan over 12 years ago

Hi Ian,
did the APs stream the channels 12 and 13 in a previous version of the beta in your region?? That would be indeed a bug as AP10 and 30 don't offer the channels 12 and 13 by design as we sell these APs in all regions.
Greetings,
Andreas
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 RFCat_vk_01 over 12 years ago in reply to treskaan

Hi Andreas,
I know they used to, but that was before this beta because I have asked about channels 12 and 13 previously.
I raised it because of the issue on the wireless protection forum.

Might as well make it not a bug in this beta but a limitation of the hardware.

Ian
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

[9.080][CLOSED]Wireless Protection AP setup

Submitted a Tech Support Case lately from the Support Portal?