[9.075][BUG] Interface shows IPv6 tunnel

Hi,
I am running this UTM with IPv6 native over PPPoE.
This UTM used to have an IPv6 Tunnel either Freenet6 or SIXXS. IPv6 tunnel configuration has the tunnel disabled, but the tunnel continues to show on the dashboard, even after a re-boot or two.

I have attached a screen shot of the dashboard interface display.

Ian

Parents

0 Astaro Beta Bot over 12 years ago

The Mantis ID #24255 is now fixed. We are planning to release a fix for this issue in Version 9.100.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 RFCat_vk_01 over 12 years ago in reply to Astaro Beta Bot

An update from my end.
I did a fresh install onto some different hardware (an older UTM 9.1b) and used the current configuration file from th eUTM with the native IPv6.
The tunnel does not appear.

So, the problem is only for those that move from a tunnel to native.

Ian
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 RFCat_vk_01 over 12 years ago in reply to Astaro Beta Bot

An update from my end.
I did a fresh install onto some different hardware (an older UTM 9.1b) and used the current configuration file from th eUTM with the native IPv6.
The tunnel does not appear.

So, the problem is only for those that move from a tunnel to native.

Ian
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data

[9.075][BUG] Interface shows IPv6 tunnel

Submitted a Tech Support Case lately from the Support Portal?