Hi All I installed the Vmware install and all started ok I get the the password screen on console, but only port 4444 is open on the firewall I can't follow the next step. Thoughts?
Use the Hypervisor console to conduct initial activation of Copernicus, eg: setting the dummy license. Also, whilst here, set the Network Configuration for PortA to a locally routable address (LAN) to then be able to connect to the web admin.
Hi
When I read the documentation it says
"Bypassing Activation and Registration
If you were to login to the web interface now, you would be prompted for activation and registration. You won’t yet be able to
complete those processes fully, so we’ll need to bypass the activation check temporarily.
*note that bypassing activation will be a temporary measure. Once the firmware is generally available, these instructions will no
longer work, and systems which were previously bypassed, will be required to activate and register.
To bypass activation, connect to the shell, via SSH. username: admin, password : admin. You cannot yet use a keyboard and
monitor connected directly to the appliance at this point.
On login, you’ll be shown a menu:
Sophos Firmware Version SFOS 15.01.0 Beta-1
Main Menu
1. Network Configuration
2. System Configuration
3. Route Configuration
4. Device Console
5. Device Management
6. VPN Management
7. Shutdown/Reboot Device
0. Exit
Project ‘Copernicus’
4
Select Menu Number [0-7]:
Select option 5, then option 3 to drop to a full shell environment. Then enter the following command:
opcode lic_dummy -ds nosync
This will disable the activation requirement during the Alpha/Beta process.
You can now log out of the shell, and log into the web interface."
If I login in Webmin (4444)
I get to put in serial number or Basic settings.
Hi
When I read the documentation it says
"Bypassing Activation and Registration
If you were to login to the web interface now, you would be prompted for activation and registration. You won’t yet be able to
complete those processes fully, so we’ll need to bypass the activation check temporarily.
*note that bypassing activation will be a temporary measure. Once the firmware is generally available, these instructions will no
longer work, and systems which were previously bypassed, will be required to activate and register.
To bypass activation, connect to the shell, via SSH. username: admin, password : admin. You cannot yet use a keyboard and
monitor connected directly to the appliance at this point.
On login, you’ll be shown a menu:
Sophos Firmware Version SFOS 15.01.0 Beta-1
Main Menu
1. Network Configuration
2. System Configuration
3. Route Configuration
4. Device Console
5. Device Management
6. VPN Management
7. Shutdown/Reboot Device
0. Exit
Project ‘Copernicus’
4
Select Menu Number [0-7]:
Select option 5, then option 3 to drop to a full shell environment. Then enter the following command:
opcode lic_dummy -ds nosync
This will disable the activation requirement during the Alpha/Beta process.
You can now log out of the shell, and log into the web interface."
If I login in Webmin (4444)
I get to put in serial number or Basic settings.
