Plugged in the first AP10:
[LIST=1]
- Power and WLAN LED lights up (no Ethernet Link LED)
- Power starts blinking for around 30s
- Power LED stays on for 10-15s
- This goes on and on and on ....
- The device is not recognized by WebAdmin
- No Ethernet link
Changed cable, nothing. Another port, nothing.
(On the same Port/Cable the "old" access point was running just 10 minutes ago without any problems, and still running fine when change it back to the old one)
NOTE to the next part:
In the meantime i found out, that the second LED (the one which looks like a monitor, does not seems to be an ethernet link LED)
Then thought, ok, lets try a reset. After some time i found out that, when i push and hold the reset button while the power is blinking, 2 or 3 seconds after the power LED stays on the ethernet link LED lights up.
The Ethernet LED was flashing from time to time like normal. But still not gets an IP address from the DHCP.
This can be repeated again and again.
OK, took the second AP10. Exactly the same. Took the AP30, the same behaviour again.
DHCP Server is a Windows 2003 Server.
Switch is a Linksys SRW2048.
Then, took a brand new Level One 5-Port Gigabit switch and placed it between the Linksys SRW2048 and the AP10 (On the same port and with the same cable as before). Within a minute, the AP10 appeared in WebAdmin.
Seems that it has problems with the Linksys switch.
Very strange....
