[8.174][BUG][OPEN] Bridge Mode Flow monitor Incorrect

Hi
Please see pic for setup.
When I look at the Traffic flow monitor on the Astaro Bridge (Br0) it does not reflect the traffic as shown on ASG 1 or ASG 2 Traffic Monitor.

Mark

Parents

0 kbr over 13 years ago

Can you give some more evidence, post some more screenshots for example?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 Mark_D_01 over 13 years ago in reply to kbr

Hi kbr
The below images are taken while a client PC was streaming a shoutcast radio station. (From the Internal network on the fmain ASG).
you clearly see that the Popup monitors are close enough, but the Dashbord display for br0 only shows 0.8 & 0.0 during most activity I have only seen it vary only a few percent from this.
Even if I have had a large download using a couple of Mbs.

I hope this helps.

Mark
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 Mark_D_01 over 13 years ago in reply to kbr

Hi kbr
The below images are taken while a client PC was streaming a shoutcast radio station. (From the Internal network on the fmain ASG).
you clearly see that the Popup monitors are close enough, but the Dashbord display for br0 only shows 0.8 & 0.0 during most activity I have only seen it vary only a few percent from this.
Even if I have had a large download using a couple of Mbs.

I hope this helps.

Mark
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data