[8.162][NOTABUG][CLOSED] Host Definition with interface IP

Hi,

it is not possible to add a host definition with an interface ip.
It says IP used as interface IP.

But it must be possible to do something like this, because when using IPV6 the interface adress has two ips. But when I want to have only the ipv4 it is only possible via an Network (255.255.255.255) Objekt.

Sven

Parents

0 da_merlin over 14 years ago

Hi Sven,

where do you want use the IPv4 address only, if the Interface has an IPv6 address too?

ALl configuration parts should handle host definitions where IPv4 and IPv6 addresses are set.

Cheers
Ulrich
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 maygyver over 14 years ago in reply to da_merlin

Lets say I want a VPN tunnel only for the ipv4 Interface IP. This is not posible when using the interface Object, because it has a IPV4 and IPV6 adress.

Doing it via a Network Definition is no option, because there are some fields (NAT) where I am not allowed to use a Network Object.

Astaro user since 2001 - Astaro/Sophos Partner since 2008
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 maygyver over 14 years ago in reply to da_merlin

Lets say I want a VPN tunnel only for the ipv4 Interface IP. This is not posible when using the interface Object, because it has a IPV4 and IPV6 adress.

Doing it via a Network Definition is no option, because there are some fields (NAT) where I am not allowed to use a Network Object.

Astaro user since 2001 - Astaro/Sophos Partner since 2008
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data