[8.162][QUESTION][ANSWERED] Wireless - why doesn't the AP pickup an IPv6 address?

All I see in the wireless security tab is IPv4 addresses, no IPv6 addresses, even though some of the devices have IPv6 addresses assigned to them? I have not seen an IPv6 address shown in any version of ASG v8 at all.

Ian

Parents

0 Astaro Beta Bot over 14 years ago

Astaro Beta Report
--------------------------------
Version: 8.162
Type: QUESTION
State: ANSWERED
Reporter: RFCat_vk
Contributor: 
MantisID: 
Target version: 
Fixed in version: 
--------------------------------

0 hschaa over 14 years ago in reply to Astaro Beta Bot

The APs itself only request an IPv4 address. So, it seems feasible to only show the IPv4 address on the "Access Points" page.

Wifi clients associated to the AP can have an IPv6 address. Are you referring to the "Wireless Status" page and the client list?

Thanks,
Helmut
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 RFCat_vk_01 over 14 years ago in reply to hschaa

Yes, I was referring to the various Wireless access security pages.

What happens when you have an IPv6 only network. I was about to try this out until I ran into a problem with my IPv6 DHCP servers?

Ian
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 hschaa over 14 years ago in reply to RFCat_vk_01

The APs currently _require_ IPv4 ...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 RFCat_vk_01 over 14 years ago in reply to hschaa

Forget that test setup for the moment.

Thank you for the explanation.

Which version is planned for IPv6 for APs?

Ian
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 RFCat_vk_01 over 14 years ago in reply to hschaa

Forget that test setup for the moment.

Thank you for the explanation.

Which version is planned for IPv6 for APs?

Ian
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data