[7.470][BUG][NOTABUG] Ethernet Bandwidth Bars

Not sure if this is a bug. There were there new status bars installed to measure incoming and outgoing bandwidth for each network interface? The percentage is still being displayed and when I upgraded to 7.470 it appears the meters had been installed but here is no bars being shown the bandwidth utilization.

Griff

Parents

0 CameronB over 16 years ago

Hi Griff,

Can you check that you have defined your Bandwidth speeds under Network>>Interfaces. Edit your external interface and add values to displayed max (out) and (in)

Once a logical value is entered in each of these you should now see a colored bar on your dashboard view.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 CameronB over 16 years ago

Hi Griff,

Can you check that you have defined your Bandwidth speeds under Network>>Interfaces. Edit your external interface and add values to displayed max (out) and (in)

Once a logical value is entered in each of these you should now see a colored bar on your dashboard view.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

0 Griff over 16 years ago in reply to CameronB

Cameron,

Setting the limits on the interface worked. While implementing your recommendation; I also used the help to lookup how to configure the interface and I there was no entry in the help section. Again thanks for the assistance.

Griff
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel