[7.460][BUG][NOTABUG] Can't configure Vonage while using Dual NIC's

OK, here is my scenario.  I am using ASG 7.460 on a P4 box with 4 NICs.
eth0  Home network  IP: 172.16.1.1  no gateway set.

eth1  Verizon DSL #1    IP: 71.x.x.x   Gateway 71.x.x.1

eth2  Verizon DSL #2    IP: 71.y.y.y   Gateway 71.y.y.1

eth3  Vonage DMZ    IP: 192.168.1.1  no gateway set

eth1 and eth2 combined using Uplink Balancing, set to Multipath. (Works Great for internet)

Packet Filter:
    Home Network --> Any --> Any
    Vonage Network --> Any --> Any

NAT
    Home Network --> Uplink Interfaces
    Vonage Network --> Verizon DSL #1

Vonage will work if Uplink Balancing is set to Failover, but not when set to Multipath.  Vonage does not work if being sent 2 different IP addrs, due to Multipath on the uplinks.  I have tried static routing, policy routing, and have tried every configuration of Multipath rules, to force the Vonage network to only use DSL #1 as the default gateway, but have had no success at all with anything.
    Can anyone offer a possible solution?
Thanks.

0 Astaro Beta Bot over 16 years ago

Astaro Beta Report
--------------------------------
Version: 7.460
Type: BUG
State: NOTABUG
Reporter: c0pperhead
Contributor: 
MantisID: 
--------------------------------

0 Gert Hansen over 16 years ago

Hi Copperhead,

did you configure a Multipath rule to bind outgoing vonage traffic to the #1 interface?

Src: Vonage Network
Svc: Any
Dst: Internet/Any
Bind to interface: Verizon DSL #1

regards
Gert
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 c0pperhead over 16 years ago in reply to Gert Hansen

Hi Gert,
Yes, I've tried every possible Multipath rule including:
Source --> Vonage DMZ
Service --> Any
Destination --> Any
itf. Persistence --> by interface
Bind Interface --> Verizon DSL #1

The Vonage traffic is not bound to this interface. It will either go to the default uplink, which is the 1st uplink set in the Multipath box, or it will use both uplinks. If it uses just 1 uplink, then it is ok. It will not work when trying to use both.
Thanks,
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel