[7.450][BUG][ACK] link aggregation for one interface only needs reboot for working

Hi

I've eth0 which is my internal interface, and eth1 which is my PPPOE (internet) interface...
I've eth2 which is not used yet.
then I create a lag for eth0 only... which does not work until I reboot... I reproduced that twice...

also the first time I tried it I got another strange problem, my PPPOE interface was no more working... I needed to restore a backup to make things work again...

thx

0 Astaro Beta Bot over 16 years ago

Astaro Beta Report
--------------------------------
Version: 7.450
Type: BUG
State: ACK
Reporter: BuBU
Contributor: 
MantisID: 
--------------------------------

0 lilith over 16 years ago in reply to Astaro Beta Bot

Hi Bubu,

can not reproduce this with 7.460...does this issue still occur on your firewall?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 BuBU over 16 years ago in reply to lilith

Hi Bubu,

can not reproduce this with 7.460...does this issue still occur on your firewall?

this was with 7.450, did not checked with 7.460, will check soon...

thx
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 BuBU over 16 years ago in reply to BuBU

Ok I can confirm that again on a brand new install for 7.450 !

adding my internal as the only lag interface does not work until I reboot...
I've same problem with another install for 7.460...

I now you do not support Virtualbox VMs but this is quite strange this is working after a reboot ? maybe some packet filter updates after switching to the new lag0 interface ?

I can provide a console access if you want to check...

thx...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 BuBU over 16 years ago in reply to BuBU

for info after the reboot... I can remove the link aggregation without rebooting... eth0 is working fine...

thx
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel