ASG 220 autonegotiation don't work

Since Version 7.075 autonegotiation don't work. I directly connect on eth5 my ACC. With Upgrade from 7.101 to 7.075 and now to 7.080 the direct connect only work with Crossover-Cable.

This may be also important for HA if the HA-Interfaces are connected directly with a "normal" non crossover-Cable.

Parents

0 Gert Hansen over 17 years ago

Hi ghauser,

what kind of hardware, especially nic's are you using in the ASG and in the ACC?

thanks
Gert
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 ClausP over 17 years ago in reply to Gert Hansen

ASG 220 autonegotiation don't work
[;)] Claus
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel
0 schmidta over 17 years ago in reply to ClausP

I assume you are using an ASG 220 rev.2 and the problems occur on eth4-eth7?

Ok, I saw you are using a normal cable to connect two 100 MBit ports?

That should not work, this is only supported on 1Gbit but not on 100MBit cards as far as i know.

So you will always have to use a cross cable for connecting two 100 MBit cards.

Do you had a setup with an older version where this setup (eth5 connected via crossover cable to another 100Mbit card) worked?
If yes, in which version?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 schmidta over 17 years ago in reply to ClausP

I assume you are using an ASG 220 rev.2 and the problems occur on eth4-eth7?

Ok, I saw you are using a normal cable to connect two 100 MBit ports?

That should not work, this is only supported on 1Gbit but not on 100MBit cards as far as i know.

So you will always have to use a cross cable for connecting two 100 MBit cards.

Do you had a setup with an older version where this setup (eth5 connected via crossover cable to another 100Mbit card) worked?
If yes, in which version?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data

ASG 220 autonegotiation don't work

Submitted a Tech Support Case lately from the Support Portal?