How to disable a radio in an APX120

Hi, As of now there is no option to disable a radio explicitly. The radio will not beacon if no SSIDs have been mapped to it. So, not mapping any 2.4GHz capable SSIDs would be equivalent to disabling a radio.

-Tejas

Thank you for replying, but that does not appear to be true in this case. The only way to stop the 2.4ghz radio interfering is by powering off the AP.

Ian

Hi, Can you provide a bit more info on this? How are you measuring interference here? The implementation is such that if no SSIDs are mapped, the radio will not beacon or emit anything. So, this should not interfere with other networks or devices that operate on the same frequency. 

Hi, Can you provide a bit more info on this? How are you measuring interference here? The implementation is such that if no SSIDs are mapped, the radio will not beacon or emit anything. So, this should not interfere with other networks or devices that operate on the same frequency. 

I am not measuring the radiation, just two of my IoT devices fail to connect when the ap is enabled. Thankfully this ap will only be used on very rare occasions so I can accept the issue at the time.

ian

I have identified the cause, now to locate the AP that is scanning and causing the drops.

Ian